Another method of restoring polar ice cover

The melting of polar ice leads to the complete breakdown of atmospheric balance, I have already written about the atmospheric conditions that will dominate over its surface. If artificiality does not restore climatic conditions, mankind may expect for twenty years the restoration of the original atmosphere.

Following the advice of people at wavelengths of 0.1, this period can be shortened and the original ground climate with a stable atmosphere can be restored within a few months.

The new technical solution must be carried out from an airplane at three 

hundred meters above the north and south polar. To restore the polar ice cover, 

a 70-volt electric discharge from the airplane must be produced, creating a 160m magnetic wire, 

an electron photon chain, at the end of the chain, not leaving the electrical discharge, 

but just placing it there. Electric discharge can be made with a pieso electric appliance, 

which is connected to a steel wire that is driven through the air blower of the airplane engine.

The 70-volt electric current is driven from the inside of the aircraft to the wire and the pieso electric device is mounted to the center of the aircraft side.

The magnetic discharging on the magnet on the cord adds many more magnet yarns. If we release 

an electrostatic discharge -8.4 degrees Celsius liquid oxygen that nearby nitrogen molecules 

energy levels with one energy level reduce, and is therefore subjected to magnetic fibers by 

chain reaction. The magnetic yarns to they are attracted to themselves a large amount nitrogen atoms, 

that between Earth and nitrogen atoms each other, acting values magnetic attraction rise so much, 

that with the nitrogen molecules full attracted magnet yarns get there on the earth surface  

and attract the water molecules themselves, and the nitrogen atoms are immediately cooled, 

and ice crystals are formed.

The icing begins on the eart’s surface and continues there. Between the airplane and the magnet yarn, there is no such thing as an attraction, it will be disconnected from the airplane. Nitrogen molecules are so cool that they have a cooling effect on the water content of the atmosphere, so the water molecules are frozen and grow until the height of the iceberg reaches 160 meters.

Giant icicles are formed because the nitrogen atoms gradually lose their negative energy levels and, they are placed in a higher atmospheric position, those negative energy nitrogen atoms that are above and have not yet sold their negative energy to water molecules are getting more nearly to the already frozen surface, and here the freezing of the water content of the air is started. If these nitrogen atoms also lose their negative energy, nitrogen atoms with newer negative energy will be they're down and will increase the existing ice layer. The negative energy nitrogen atoms, so they are always starting to be released on the surface of the newly formed ice, and they are becoming more and more ice-sheet.  Always with the freshly formed ice layer contacting air temperature is cooled, as long as the nitrogen atoms lose their negative energy levels.  In the elevated air layers upwards, less and less nitrogen, freezing of less and less water molecules, so the confused water molecules take on the typical icicle form.

The glaciation of the Arctic will follow the path of the airplane, ice formation is not evenly, 160 meters high ice columns, as if giant icicles were standing out of the surface, all of which are related to aprox. 20 meters high with flat ice layers.  Arctic ice-generation throughout the Arctic is sufficient to produce five bottles of liquid oxygen.

Two months and two weeks later it must be repeated again, the result is 250 m high icicle, 30 m high with a connected ice cover. Then again, after three months and two weeks repeated, the result is icicle of three hundred meters high, with a connected ice layer of 35 meters high. Then again repeated, after three months and two weeks, the result is icicle of three hundred meters high, with a connected ice layer of 35 meters high. Ice can cover the entire if the airplane's route covers the entire polar region, then five bottles of liquid oxygen are enough for the entire operation. Human intervention is no longer necessary as this amount of ice is sufficient to trigger natural ice formation. To restore the original ice cover approx. still need 10-12 days. Natural ice formation
  it starts, because the 250-meter-long icicle, are frozen flat ice layers between them
  they produce a temperature of -10 degrees Celsius. In the vicinity of the Arctic Circle, the atmospheric subdivisions of energy levels are already being built, there is always one less air layers of energy they follow each other. From the inside of the mainland incoming air mass influx so it slows down, always only air layers have one less energy level can reach the Arctic. The slow coming airflow in turn to the existing ice formations exfoliated are frozen, and more and more ice masses are created, which will reach the original amount of ice in 10 to 12 days. At the 160 m icicle height, it is necessary to repeat the artificial ice-cooling, because it only cools to -5 degrees Celsius in the arctic climate and during the formation of ice layers -1 Celsius degree will be temperature, energy level rise. While reaching the 250 m high icicle  -5 degrees Celsius will be the temperature, which is enough to cool the slowed air streams to the freezing point. As the ice layer thickens, the increasing ice masses resulting in a colder climate, until it reaches a temperature value of 70 degrees Celsius in an undisturbed polar climate.

The easiest way to get in touch with the 0.1 wavelength

If the computer and the monitor's cable are covered with fullerene in the electric wiring 

harness of the plugs, they are loosely packed up to the power plugs, increasing the 

flow rate of the electrons.

Insulation is no longer required as fullerene moves the electrons forward, does not move in 

any other direction, has fulleren with the greatest magnetic attraction, so there is no risk 

of electric shock. The acceleration speed of the electrons accelerated by fulleren allows 

the connection to be established since the signals are first received at 0.1 wavelengths. 

Image and voice change will be unambiguously fast, so you will need to slow down. 

At the top of the computer at a distance of approx. one piece 3x3 cm magnet should 

be placed.

The flow of information signals, the attraction of moving electrons in the power lines, 

provides over the wire. However, the magnet attracts the information codes towards 

itself, and the fullerene is backward.

However, we need to initiate a contact, but we need to initiate our wavelength, and 

wait for it, but no response will arrive, so the picture and sound will be displayed. 

The information patterns dissipate as a result of magnetic attraction to information patterns 

that are once again attracted to fullerene-treated wires. Here they fit into patterns again. 

Here they fit into patterns again. The amount of time elapsed during the protuberance and 

patterning ensures the traceability of image and sound.

When communication with the wavelength of 0.1 is completed, you need to ask the contact 

partners at down. They can receive the information signals there, a minute later, the pictures 

transmitted the wavelength of 0.1 to place the computer on the original network, 

they are only able to do this. 

You will need to remove the magnet from your computer, and you will no longer need 

to slow from the wavelength of the caller's computer monitor are displayed with sound.

Az űrlap alja

Az űrlap teteje